![]() ![]() While mountain bikers discovered this and adopted the technology quickly, the road bikers have been slow. Tubeless tires have revolutionized and changed the bike industry for the better. Taping is the first step, and the most critical in the tubeless setup - be sure to take your time, and do so carefully. Using a small pick to create an initial hole helps, and is the best practice. Finally, insert the valve through the tape should be done carefully to make sure the tape doesn’t tear out from the valve hole. ![]() Similarly, making sure the tape is evenly applied across the rim channel, with just a few millimeters extending up onto the sidewalls of the channel will ensure a proper seal throughout. If there are wrinkles or places where the tape hasn’t adhered, this will likely result in larger issues later. Make sure the tape fully contacts the rim, do not leave a gap between the tape and the centermost part of the rim. When starting the tape be sure to start 1-2 spoke holes before the valve stem hole and end 1-2 spoke holes past the valve stem hole. We recommend wiping it down with isopropyl alcohol to ensure proper adhesion of the tape. You must make sure the rim surface is clean. Here are the most common setup mistakes or misconceptions that lead to larger issues or a bad experience. We see every mistake in the book when it comes to tubeless setups and most involve the taping of the rim and installation of the tire itself. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |